19
!
!
Bandsaw
N2-38 / N3800 / N4400
Warning! Risk of injury!
Risk of injury! Keep machines, tools and accessories etc. out of the reach of children.
Vacuum hoses and electrical wires should be layed in such a way as to avoid tripping over them.
6 Setup and installation
6.1 Safety instructions
Warning! Risk of injury! Improper assembly and installation can lead to serious physical injury or equipment
damage. For this reason, this work may only be carried out by authorised, trained personnel who are familiar
with how to operate the machine and in strict observance of all safety instructions.
• Ensure that there is sufficient space to work around
the machine. Ensure there is ample distance be-
tween the machine and other solid constructions
such as a walls or other machines.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Install the safety equipment according to the
instructions and check that it functions properly.
Setup and installation
6.2 Installation site requirements
• Operation/room temperature: +10° to +40° C
• Ensure that the work surface is sufficiently stable and
has the proper load-bearing capacity
• Provide sufficient light at the workstation
• Ensure there is sufficient clearance for or from
neighbouring workstations
Attention! Risk of material damage!
The machine may only be used in a dry and frost-free environment and may not be used outside.
Attention! Risk of material damage!
Only operate the machine in ambient temperatures from +10°C to +40°C. If the instructions are not followed,
damage may occur to bearings.
Warning! Risk of injury! An incomplete, faulty or damaged machine can lead to serious physical injury or
equipment damage. Only assemble and install the machine if the machine and its parts are complete and
intact.
Warning! Danger! Electric current!
Work on electrical fittings may only be carried out by qualified personnel and in strict observance of the safety
instructions.
The floor space around the machine must be flat, well
maintained, free of obstacles and cleared of waste mate-
rial such as chips and offcuts.
To Next Page
Loading...
