Hammer N2-38 - Mitre Cuts; Circular Cuts; Diagonal Cross-Cut of Rectangular Workpieces

30
Bandsaw
N2-38 / N3800 / N4400
Operation
Use auxiliary equipment as depicted in the figure.
Fig. 7-14: Cross cut
7.7.7 Diagonal cross-cut of rectangular workpieces
Fig. 7-13: Circular cuts
7.7.6 Circular cuts
7.7.5 Mitre cuts
Use auxiliary equipment as depicted in the figure.
Fig. 7-12: Mitre cuts
Use auxiliary equipment as depicted in the figure.
Accessories Order no.:
01.1.300