Hammond B-3 - Page 89

89
Setting the Parameters
PRESET PARAMETERS
Equalizer and Reverb are Preset Parameters, de-
signed to be actively used as one of the tone-mak-
ing parameters.
If you are using the EQ and Reverb to compensate
for the space you are performing in, It is advisable
to switch off the P.LOAD EQ/RV in the Preset func-
tion mode so, the Equalizer and the Reverb value
will not change when a preset is recalled. (P. 77
#11)
REVERB
8. REVERB - DEPTH
This sets the Depth of the Reverb Effect.
The setting range is 0 - 15. As you increase the value, it will give the effect of performing in a
larger room.
NOTE: You can locate this page by moving [REVERB] knob pressing the [MENU/EXIT] button.
9. REVERB - TYPE
This sets the Types of Reverb Effect.
Room 1Room 1
Room 1Room 1
Room 1: Small room
Room 2Room 2
Room 2Room 2
Room 2: Large room
LiveLive
LiveLive
Live: Ambient room
Hall 1Hall 1
Hall 1Hall 1
Hall 1: Large Hall
Hall 2Hall 2
Hall 2Hall 2
Hall 2: Small Hall
ChurchChurch
ChurchChurch
Church: Church
PlatePlate
PlatePlate
Plate: Iron-plate Reverb
SpringSpring
SpringSpring
Spring: Spring Reverb
DelayDelay
DelayDelay
Delay: Delay
PP
PP
P
anDlyanDly
anDlyanDly
anDly: Panning Delay
RevDlyRevDly
RevDlyRevDly
RevDly: Reverb + Delay
10. REVERB - TIME
When the Type (9) is set at Room 1 to Spring or RevDly, it sets the Time for Reverb to decay.
The setting range is 0 - 31. The higher the value, the longer the decay.
11. REVERB - DELAY TIME
When the Type (9) is set at Delay, PanDly, RevDly, this sets the delay time.
The setting range is 4.7 - 2000 ms. The higher the number, the longer the delay.
NOTE: You can set the delay time with the foot switch (P. 91 #4).
12. REVERB - DELAY FEEDBACK
When the Type (9) is at Delay, PanDly, RevDly, it sets the amount of Feedback. (How many
times the sound repeats.)
The setting range is 0 - 96%. The higher the value, the more repeats.
13. LESLIE ON REVERB
This sets the routing of the Reverb and Leslie Effect.
OFOF
OFOF
OF: Leslie before Reverb
ONON
ONON
ON: Reverb before Leslie
NOTE: These parameters are Preset Parameters and are recorded to each Combination Preset.