96
*#1 $OM%OM$2OMOwner’s Manual
SYSTEM
1. PEDAL PART - OUTPUT
This is for setting which jack to outputs the Pedal part.
BB
BB
B
OTHOTH
OTHOTH
OTH: Outputs the Pedal part to all the sound output jacks.
PEDPED
PEDPED
PED
ALAL
ALAL
AL: Outputs the Pedal part only to the PEDAL OUT jack.
2. PEDAL PART - REBOUND TIME
The Pedalboard sometimes sounds twice caused by the “rebound” which happens when
the keys are played staccato and released, depending on the condition of the sheet spring
used on it. This can be avoided by adjusting the “rebound time”.
The setting range is 1 - 128 x 1.4 msec. The initial value is 40 x 1.4 msec.
NOTE: If the rebound time is too long, it causes a sound delay.
3. PEDAL PART - MIDI MESSAGE
“*” is displayed while the Pedal part sound is output by the MIDI message from the PEDAL
MIDI IN jack.
4. DRAWBARS - CONTROL MODE
This sets the condition for activating the registrations with the Manual Drawbars.
A#/B:A#/B:
A#/B:A#/B:
A#/B:
The Drawbars are active only when the Preset Keys [A#] and [B] are selected,
same as the original B-3/C-3.
ALAL
ALAL
AL
WW
WW
W
AA
AA
A
YS:YS:
YS:YS:
YS:
The Drawbars are active regardless which Preset Keys are selected, same as the
XK-3.
5. - 12. VERSIONS
These are the versions of each software built in this organ.
These are only for displaying the version number.
In this mode, you can set the SYSTEM PARAMETERS of this organ and the display infor-
mation.
To locate this mode:
Press the [MENU/EXIT] button to display the MENU, select PAGE D by the [PAGE] button,
and then press the [2] SYSTEM button.
1 2 3
5 6 7
8 9 10
11 12
4
To Next Page
Loading...
Need help?
General
