EasyManuals Logo

Hammond XPK-100 User Manual

Hammond XPK-100
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
13
Advanced Features
Hammond XPK-100 Quick Features Guide
Current Parameter Current Value
Current Parameter Your Selected Value
Current Parameter Current Value
TRY THIS - To transpose the XPK-100 using EDIT Mode:
1. From PLAY Mode, press the PLAY/EDIT Switch once. The Information Center Display
should alternate between two messages as shown below:
2. Press the PRESET/EDIT Switch repeatedly until the Information Center Display
alternates between two messages as shown below:
NOTE: You can also press the PRESET/EDIT Switch to arrive at the same Advanced Feature selection.
3. Now use the Pedal keys to select the Transpose value you want. The data chart below
shows how to do this.
TRANSPOSE OPTIONS
Transposition Interval Action
No Transposition Press the “Lo C” Pedal
Up 1 half-step Press the “C< Pedal
Up 2 half-steps Press the “D” Pedal
Up 3 half-steps Press the “D< Pedal
Up 4 half-steps Press the “E” Pedal
Up 5 half-steps Press the “F” Pedal
Up 6 half-steps Press the “F<< Pedal
Down 5 half-steps Press the “G” Pedal
Down 4 half-steps Press the “G<< Pedal
Down 3 half-steps Press the “A” Pedal
Down 2 half-steps Press the “A< Pedal.
Down 1 half-steps Press the “B” Pedal
4. When you have made your selection, then press the Hi “C” Pedal once. The Information
Center Display will show you the current parameter alternating with your selected value:
5. To exit the EDIT Mode and return to PLAY Mode, press the “Hi C” Pedal again. The XPK-
100 is now transposed to the value you selected.
NOTE: After doing the above, you will notice a small red dot between the first and second characters of the
Information Center Display. This indicates that your new value has not been saved to a Preset. For information
on how to save your settings to a Preset, see page 34.
6. To continue editing, instead of pressing the Hi “C” Pedal, use the PRESET/EDIT Switches
to select the parameter you want to edit. When you are finished editing, press the “Hi
C” Pedal once to return to PLAY Mode. All of your changes will now take effect.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hammond XPK-100 and is the answer not in the manual?

Hammond XPK-100 Specifications

General IconGeneral
BrandHammond
ModelXPK-100
CategoryMusic Pedal
LanguageEnglish

Related product manuals