16
Advanced Features
Hammond XPK-100 Quick Features Guide
Current Parameter
Current Parameter
Current Value
Your Selected Value
Current Parameter Current Value
Ë Advanced Feature - E03 Poly/Mono Mode
This Advanced Feature allows you to select either “Poly” (polyphonic - more than one pedal note will
play at the same time) or “Mono” (monophonic - only one pedal note will sound if two or more pedal
keys are pressed together) Mode. The default setting is “Mono.”
TRY THIS:
1. From PLAY Mode, press the PLAY/EDIT Switch once. The Information Center Display
should alternate between two messages as shown below:
2. Press the PRESET/EDIT “” Switch repeatedly until the Information Center Display
alternates between two messages as shown below:
NOTE: You can also press the PRESET/EDIT “” Switch to arrive at the same Advanced Feature selection.
3. Now use the Pedal keys to select between Poly and Mono Mode.
Use the WHITE Pedal keys (“Lo C” “D” “E” “F” “G” “A” and “B”) to select Poly Mode.
Use the BLACK Pedal keys (“C<” “D<” “F<” “G<” and “A<”) to select Mono Mode.
4. When you have made your selection, then press the Hi “C” Pedal once. The Information
Center Display will show you the current parameter alternating with your selected value:
5. To exit the EDIT Mode and return to PLAY Mode, press the “Hi C” Pedal again. The XPK-
100 is now set to the value you selected.
NOTE: After doing the above, you will notice a small red dot between the first and second characters of the
Information Center Display. This indicates that your new value has not been saved to a Preset. For information
on how to save your settings to a Preset, see page 34.
6. To continue editing, instead of pressing the Hi “C” Pedal, use the PRESET/EDIT Switches
to select the parameter you want to edit. When you are finished editing, press the “Hi
C” Pedal once to return to PLAY Mode. All of your changes will now take effect.
To Next Page
Loading...
Need help?
General
