Operation
32
4.6.5 Separating the frame parts
See fig. 000000019.
The scooter can be separated into two
parts. This is done as follows:
• Remove the carrier basket.
• Lift the narrow end of the catch (A) up
from the center of the bottom (B).
This will unlock the coupling system.
• Tilt the back part (C) back until it is
resting on the bumper.
• Take hold of the front part of the scooter
with one hand on the handlebars and
one hand on the handgrip.
• Lift the front part up to separate it from
the back part.
The frame parts should be reassembled as follows:
• Leave the back part resting on the bumper.
• Take hold of the front part and make sure it is at right angles with the back part.
• Lift up the front part, keeping one hand on the handlebars and one hand on the
handgrip.
• Slide the slots of the front part over the pins of the back part.
• Next, tilt the back part forward by slowly moving the seat tube upward.
Make sure that, while doing so, the cables do not get caught.
• Replace the carrier basket.
4.6.6 Folding down the steering column
See fig. 000000020.
The steering column can be folded down
as follows:
• Loosen the locking handle (A) by turning
it to the left (anti-clockwise).
• Push in the spring-loaded catches (C) on
both sides of the steering column (B).
• Fold down the steering column.
• Tighten the locking handle (A) again by
turning it to the right.
This will lock the steering column.
Use caution when folding
down the steering column,
to avoid getting your
fingers caught.
The steering column is replaced in its correct position by carrying out the above actions
in reverse order.
To Next Page
Loading...
