Hangar 9 Extra 260 - Additional Required Tools and Adhesives; Warning

4
An RC aircraft is not a toy! If misused, it can cause serious bodily harm and damage to property. Fly only in open
areas, preferably at AMA (Academy of Model Aeronautics) approved flying sites, following all instructions included
with your radio and engine.
Tools
• 4-40 tap
• Adjustable wrench (small)
• Canopy scissors
• Drill (drill press preferred)
• Drill bit: 1/16", 3/16", 5/64", 7/32", #43, 5/32"
• Drum sander
• Cut-off wheel
• Flat blade screwdriver w/short handle
• Foam: 1/4"
• Hex wrench: 3/32"
• Hobby knife
• Masking tape
• Phillips screwdriver (small)
• Razor saw
• Scissors
• Square
• Syringe
• Tap handle
• Toothpicks
• Velcro straps
Adhesives
• 30-minute epoxy
• Medium CA (cyanoacrylate) glue
• CA remover/debonder
• Pacer Z-42 Threadlock
• Pacer hinge glue (PT-55)
• Formula 560-canopy glue
• Shoo Goo
Other Required Items
• Epoxy brushes
• Felt-tipped pen or pencil
• Measuring device (e.g. ruler, tape measure)
• Mixing sticks for epoxy
• Paper towels
• Petroleum jelly
• Rubbing alcohol
• Sanding bar
• Sandpaper (coarse)
• Covering Iron (HAN101)
• Dental floss or string
Additional Required Tools and Adhesives
Warning