40
1． Inspect electrolyte
The storage battery without a dobber
It is proper to pour the electrolyte 15-20mm
above the electrode plate.
The storage battery with a dobber
According to the dobber of the ventilation
cover, read the level position of the
electrolyte.
2． Replenish the distilled water
·Wear the blinkers, rubber shoes and
rubber glove.
① Use the measuring cylinder to take out
the distilled water with a certain
quantity.
② Open the battery ventilation cover or fill
cap.
③ Imbibe distilled water with injector and
then supply it into the storage battery.
The storage battery with a dobber
When the red dobber rises, the white line
appears, please stop replenishing.
The storage battery without a dobber
When the electrolyte is above 15-20mm of
the electrode plate, stop replenishing
④ After replenishing the distilled water,
close the ventilation cover and box cap.
⑤ Use the damp cloth to clean the
surface of storage battery cells.
WARNING
It is not permitted to exceed the
appointed top level when
replenishing the distilled water.
Adding too much will result in
leakage of electrolyte, and it will
damage the truck when charging or
discharging.
Draw it out with injector if adding too
much.
3． Reading the specific gravity
1）The specific gravity of the electrolyte will
change as the temperature changes.
To Next Page
Loading...
