74
1.1.2 Dismount and assemble order
Dismount and disassemble the reduction box according to the following order:
– Dismantle driving wheel (wheels);
– Open oil discharging bolt and discharge the oil;
– Disassemble swing bearing and top shell articles;
– Disassemble driven cylindrical gear
– Open the cover, disassemble driven spiral bevel gear and output flange etc.
1.1.3 Notice to installment and use
– Before installing, you should wipe the oil on the surface of the shell.
– In case that the oil leaks during use, you are not allowed to dismount and disassemble the
product.
– Prevent the assembling surface and exposed flange from being knocked or damaged,
otherwise it may influence the installment and use precision.
– Working oil should keep clean, the new machine should change new oil in 50 hours for the
first use and every 1000 hours later.
– Working oil should in accordance with brand no.（GL-5 85W/90）.
1.1.4 Fault and troubleshooting
Fault Probably cause Method of Fault eliminating
Low efficient transmission and
overheat oil temperature
① Lack of oil
Add oil
② Quantity of the oil is
Replace
③ Gear or bearing is
Replace
Unstable running
①Gear or bearing is damaged
Replace
Oil leakage
① Wear or damage of oil seal
Replace
②Leakage from the gasket
Screw bolt or replace
To Next Page
Loading...
