8
1.4.1 Display
Curtis 840 Instrument [2]
Dot-matrix LCD display
The display screen is 8 alphanumeric
characters, dot-matrix LCD liquid crystal
display, can display vehicles fault code, battery
soc and total running time.
Vehicles when the normal operation of the
display shows the battery remaining power.
Service indicator(red LED)
When the controller to detect fault information,
the red LED indicator light flashing, at the
same time LCD display shows two digits of the
fault code.When there are multiple fault fault
code alternates between interval of 2
seconds.Fault code corresponding fault
information to view in this paper, the fault code
table.
BDI indicator(yellow LED)
When battery remaining power less than 20%,
the yellow LED indicator lights flashing,
warned "depleted", at the same time LCD
display shows "20%" for 1 seconds after into
"Low BDI".
When the yellow LED indicator lights flashing,
vehicle lifting by automatic locking function,
running speed is reduced.At this time should
be immediately available for vehicles
recharged.
Hourmeter indicator(green LED)
Said when the green LED light is normally on
the timer is timing, the smallest unit of time for
0.1 hours.
Every time when starting the vehicle LCD
screen will display the vehicle's total run time,
this time is for regular maintenance on the
basis of the vehicle.
Zapi MDI-CAN Instrument [2]
LED function
The MDI-CAN has only a LED. This LED
is red and lights and blinks when an alarm is
present.
Display function
Three symbols inform the operator as
follows:
Turtle Symbol:
It is normally off; when it appears (fixed) it
shows activation of the “soft” mode of the truck,
in which maximum speed and acceleration are
reduced;
Monkey Wrench Symbol:
ALARM LED LCD DISPLAY
To Next Page
Loading...
