high speed easy control .
② two archives speed and acceleration design ，can apply to most situation.
③ regeneration technology make change direction of fork even smooth。
④ three regenerative braking mode ：
A、acceleration pedal part release appear regenerative braking，
B、direction reverse regenerative braking，
C、ramp downslide appear regenerative braking，
Except increase security drive，reclaim part of electric energy，prolong work time of every time .
⑤ control speed during downgrade： speed lie on accelerator 。if speed exceed set point，controller
may automatic braking，this give optimal ramp.
Notice:
1 .Maintain electric control ，must first cut off electrical source，then hold 10-100ohmic resistance
join controller anode and cathode，release residual voltage in the capacitor, or else you may meet
tip-and-run danger.
2.Magnetic and radiation have some effect to inverter，long time effect may mangle controller, So
need apart form magnetic and radiation.
To Next Page