HANGCHA CPD30J - Page 54

48
(3)Errors detected by drive ACS (Warning)
Code
Source
Condition
When
Tract
Main
PS
Reset
Remark
201
ACS low temp warning
ACS heat sink temp < -20 ℃
KEY=ON
ON
ON
ON
KEY=OFF or Heat
sink temp normal
Lowest Accel will be used.
202
ACS high temp warning
ACS heat sink temp > 85 ℃
KEY=ON
ON
ON
ON
KEY=OFF or Heat
sink temp normal
Lowest Accel will be used.
203
Motor high temp warning
Motor temp > 145 ℃
KEY=ON
ON
ON
ON
KEY=OFF
Lowest Accel will be used.
204
Heat sink temp sensor error
ACS heat sink temp
sensor error
KEY=ON
ON
ON
ON
KEY=OFF
Lowest Accel will be used.
205
Motor low temp warning
Motor temp < -50 ℃
KEY=ON
ON
ON
ON
KEY=OFF
Lowest Accel will be used.
206
Motor temp sensor error
Motor temp sensor
not connected or short circuit
KEY=ON
ON
ON
ON
KEY=OFF or sensor
connected
Lowest Accel will be used.
207
Speed feedback sensor error
Speed feedback sensor
not connected / short circuit
KEY=ON
ON
ON
ON
KEY=OFF or sensor
connected
ACS can not control speed
correctly. No driving allowed.
208
ACS high voltage warning
ACS voltage > 68V
KEY=ON
ON
ON
ON
KEY=OFF or voltage
back to normal
Lowest Accel will be used.
209
ACS low voltage warning
ACS voltage < 22.5V
KEY=ON
ON
ON
ON
KEY=OFF or voltage
back to normal
Lowest Accel will be used.
210
ACS default values loaded
Default parameters are used
in ACS
KEY=ON
ON
ON
ON
KEY=OFF
Turn the key s witch off and on again.
211
Power reduce
Power is reduced (by
some warning condition)
KEY=ON
ON
ON
ON
KEY=OFF
212
Checksum error
Calibration parameter
checksum error
KEY=ON
ON
ON
ON
KEY=OFF
213
PCB low temp warning
PCB temp <-20 ℃
(onlyGEN4，GEN5 not )
KEY=ON
ON
ON
ON
KEY=OFF
214
PCB high temp warning
PCB temp > 100 ℃
(only GEN4，GEN5 not )
KEY=ON
ON
ON
ON
KEY=OFF
215
PCB sensor error
PCB temperature sensor error
(only GEN4，GEN5 not )
KEY=ON
ON
ON
ON
KEY=OFF
216
Current sensor default error
Current check default error
KEY=ON
ON
ON
ON
KEY=OFF