11
Note: The last measurement value will be displayed until the next sample is measured or the
instrument is turned off. Temperature will be continuously updated.
Note: The ”ATC” tag blinks and automatic temperature compensation is disabled if the
temperature exceeds the 10-40 °C / 50-104 °F range.
4. Remove sample from the sample well by absorbing on a soft tissue.
5. Using a plastic pipette, rinse prism and sample well with distilled or deionized water. Wipe
dry. The instrument is ready for the next sample.
TO CHANGE MEASUREMENT UNIT (HI 96813, HI 96814)TO CHANGE MEASUREMENT UNIT (HI 96813, HI 96814)
TO CHANGE MEASUREMENT UNIT (HI 96813, HI 96814)TO CHANGE MEASUREMENT UNIT (HI 96813, HI 96814)
TO CHANGE MEASUREMENT UNIT (HI 96813, HI 96814)
For HI 96813 only:
1. Press the RANGE key to select measurement units of %Brix or % potential alcohol. The
instrument toggles between the two measurement scales each time the key is pressed and
the primary display indicates “bri” for %Brix or “P.ALc” for potential alcohol. When the
instrument displays the screen with 4 dashes, the instrument is ready for measurement. A
number on the display indicates the selected unit: “1” denotes %Brix and “2” denotes
potential alcohol as indicated on the instrument cover.
2. The potential alcohol scale also indicates the conversion factor chosen for the potential
alcohol reading. See TO CHANGE POTENTIAL ALCOHOL CONVERSION FACTOR (page 13) to
change the current factor.
Note: When changing ranges the presently configured conversion factor will be displayed in the
lower display. (See page 13)
To Next Page
Loading...
