19
GETTiNG STArTED
4. To open the latch, press the clip inward while pulling up the latch.
Insert clip Close clipOpen clip
press
pull
Easy to install and able to accomodate several cables, the clip secures the cabling by allowing cables
to move freely with the arm motion.
Using the adapter
The electrode holder at the end of the arm has three different-sized apertures:
• One located center-front (temperature probe only)
• One located center-back (pH probe with adapter only)
• Two located sideways, left and right (pH probe only, no adapter required)
When a center-positioning of the probe is required:
1. Orient the adapter such that the positioning marks align with the positioning marks on the
electrode holder.
2. Insert the adapter slowly into the holder keeping the positioning marks on the adapter and
electrode holder aligned with each other.
If the adapter appears blocked, it may need to be rotated slightly to correctly engage the guides.
3. Using medium to light pressure, push the adapter down until it securely clicks in place.
4. Insert the electrodes into the openings and clip the cables through the top-entry cable clip.
A
d
a
p
t
e
r
Cable clip
Positioning
marks
Electrode holder
Knobs
To Next Page
Loading...
