Hanna Instruments HI6221 - Getting Started; Attaching the Electrode Holder

18
GETTiNG STArTED
8. GETTING STARTED
8.1. ATTACHING THE HI764060 ELECTRODE HOLDER
Attaching the electrode stand and arm
• Take the HI764060 electrode holder from the box.
• Identify the metal base plate (4) with the integrated pivot pin (5) and the screw (2).
• The plate may be attached to either side of the meter, left (L) or right (R).
• Place the meter face down on a clean, dry surface.
• Align the base plate over the rubber foot (6R or 6L) and hole (3) on the meter case. The pivot pin
(5) should be facing downward.
• Use a screwdriver (1) to tighten the screw (2) and attach the base plate to the meter.
R
R
L
1
2
3
4
5
5
7
6L
6R
• Position the meter with the display facing up.
• Slide the electrode holder (7) over the pivot pin (5).
• Insert the electrode holder into the metal post in the base plate. Only a “slide in” motion is required
to lock the arm into position.
• For increased arm rigidity, tighten the metal knobs on both sides of the electrode holder.
The electrode arm has an electrode holder on the end of it.
Attaching the cable holder clip
To secure the cabling, fasten the plastic clip onto the electrode arm by following the steps:
1. Align the clip’s dovetail over the slot.
2. Gently push down to slide in position.
3. To close the latch, lower latch over cable and snap closed.
The latch snaps in position and secures the cables inside.