51
mEASurEmENT & ELECTrODE SETuP mENu
10.5. ALARM
Options: High pH, Low pH, High mV, Low mV, High Temperature, Low Temperature
Option allows users to set the threshold limits for the measured parameters.
When the parameter is enabled and the the measurement exceeds the high-limit value or drops below
the low-limit value, the alarm is triggered.
An alarm message will appear on the message banner. If the Alarm Beeper is enabled (System Menu /
System / Alarm Beeper), an audible beep will be heard.
Note: high-parameter values cannot be lower than low-parameter ones.
To set an alarm limit:
1. Tap on switch to enable low or high parameter threshold option.
2. Use the on-screen keypad to enter the value.
3. Tap Enter to confirm or Cancel to exit and return to measurement setting options.
To Next Page
Loading...
