15
• To switch ON or OFF the electrode condition indicator on the
LCD, press the SET button; press
to exit setup options; Change the set
with the SET button, then press
to confirm and to return to normal
mode.
METER SETUP
BATTERY REPLACEMENT
When the remaining battery life is less
than 10% the battery tag blinks on the
display to warn the user.
Battery Error Prevention System (BEPS)
If the battery is too weak (“0%”) the display shows
“bAtt“, “DEAD“ for few seconds then the meter power off.
Immediately replace the batteries with new ones.
The batteries are accessed by opening the battery cover
on the back of the instrument. Remove protective boot
if present.
BATTERY REPLACEMENT
Impex Produkter
To Next Page
Loading...
Need help?
General
