8
1 pH calibration buffer(s) used
2 Stability indicator
3 Primary LCD
4 Battery percentage
5 Secondary LCD
6 Electrode condition indicator
7 Low battery indicator
8 Measurement unit
9 Automatic Temperature Compensation indicator
10 Third LCD
11 Temperature unit
12 Meter modes indicator
Each meter is supplied with batteries. Before using the
meter for the first time, open the battery compartment
and insert batteries, observing the polarity (see “Battery
Replacement“).
TO CONNECT THE ELECTRODE
With the meter turned off, connect the HI12973 probe to the
DIN socket on the bottom of the meter by aligning the pins
and pushing in the plug firmly. Remove the protective cap
from the probe before taking any measurements.
DISPLAY DESCRIPTION
OPERATIONAL GUIDE
Impex Produkter
To Next Page
Loading...
