Hansa C16 O&M Manual - OM-009 Revision G 26/09/2019
© Hansa Chippers 2019
What can my Hansa chipper process?
Intended uses of the chipper
The Hansa C16 chipper is built to process organic material including wooden branches not exceeding 110 mm in diameter. It is
designed to be used on a regular basis by semi commercial garden maintenance contactors and hire / rental companies. Do NOT
use the chipper for any other purpose.
Prunings, stalks, roots, vegetable matter, hay, grass, bark
Dead and hard timbers (Note: these will dull the knives faster)
Soil, bones, sand, grit, stones, metal
If you have any questions, contact your authorised dealer.
Do NOT exceed 110 mm branch diameter
Receiving your Hansa chipper
You may receive your chipper assembled from your dealer or it may arrive in a crate. Assembly takes approximately 30 minutes,
two people working together will make the assembly easier.
Chipper components
To Next Page
Loading...
