Hantek DSO2C15 User Manual

DSO2000 Series Digital Storage Oscilloscope
User Manual
（V1.4）

Hantek DSO2C15 Specifications

General

Bandwidth	150 MHz
Sample Rate	1 GSa/s
Channels	2
Vertical Resolution	8 bit
Trigger Type	Edge, Pulse, Video, Slope, Alternate
Interface	USB, LAN
Math	+, -, *, /, FFT
FFT Windows	Rectangular, Hanning, Hamming, Blackman
Display	7 inch TFT LCD
Vertical Sensitivity	2 mV/div to 20 V/div
Automatic Measurement	Vpp, Vmax, Vmin, Vtop, Vbase, Vamp, Vavg, Vrms, Period, Freq, Rise Time, Fall Time, +Width, -Width, +Duty, -Duty
Input Impedance	1 MΩ ± 2%
Timebase Range	5 ns/div - 50 s/div

Summary

General Safety Summary

1.4. The User Interface

1.5. Functional Check

1.5.1. Connect the Oscilloscope

Procedure for connecting the oscilloscope probe to Channel 1.

1.6. Probe Introduction

1.6.2. Manual Probe Compensation

Steps to adjust probe compensation for accurate measurements.

2. Function Introduction

2.1. Menu and Control Keys

Description of the oscilloscope's menu and control buttons.

2.4. Oscilloscope Setup

2.5. Horizontal Controls

How to adjust horizontal scale and position of the waveform.

2.6. Vertical System

2.7. Trigger System

2.7.1. Edge Trigger

Configuring the oscilloscope to trigger on signal edges.

2.7.2. Pulse Trigger

2.7.3. Video Trigger

2.8. Protocol Decode

2.10. Measure System

2.10.3. Automatic Measurement

Performing automatic waveform parameter calculations.

2.12. Acquire

2.12.1. Run Control

2.14. Utility System

2.15. Fast Action Buttons

2.15.1. AUTO SCALE

2.15.2. Default Setup

3. Waveform Generator

3.1. Set Wave Type and Parameters

Selecting and configuring waveform types and parameters.

4. Remote Control

5. Troubleshooting

6. Services and Support

7. General Care and Cleaning