8.
The pull chain extensions (F) supplied in one of
the hardware packs or custom pull chain
extensions (not included) may be attached to the
fan and light pull chains.
9.
FINAL INSTALLATION
8
9
13
Lowes.com/harborbreeze
E
(For Fan)
(For Light)
F
Locate rubber washer (T), finial plate (H), and
finial (I) that were removed in Step 4 of this
section. Place rubber washer (T) inside glass
shade (E) over center hole. Align hole in center
of glass shade (E) with threaded rod on light kit
fitter (D), allowing pull chains to come through
corresponding holes in glass shade (E). Push up
gently on glass shade (E) until threaded rod
comes through hole. (Be sure fan pull chain does
not rub against bulbs during fan operation.)
Align hole in center of finial plate (H) with
threaded rod, allowing the pull chains to come
through appropriate holes in finial plate (H) and
push up. Thread center pull chain through hole in
finial (I) and secure glass shade (E) by tightening
finial (I).
NOTE: Do NOT overtighten finial (I) as glass
may crack or break.
I
H
T
D
To Next Page
Loading...
Need help?
General
