10
FINAL INSTALLATION
Install the four 7-watt candelabra base bulbs (C)
provided into the sockets on the mounting plate (A).
(Fig. 2)
2.
1.
A
B
1
Locate mounting plate nuts (EE) in one of the
hardware packs.
Remove motor assembly (B) from "J" hook. Align
holes in the bar at the top of the motor assembly (B)
with bolts on underside of mounting plate (A) and
push up until bolts come all the way through the
holes. Secure motor assembly (B) with mounting
plate nuts (EE). (Fig. 1) Make sure to tighten all
mounting plate nuts (EE) completely.
Socket
CC
EE
EE
2
B
C
A
Socket
Mounting Plate Nut x4
Hardware Used
EE
It is advisable to check that the wiring has been
done correctly before proceeding. Connect the
male plug from the switch housing to the female
plug from the light kit fitter (F). Make sure that the
plugs connect tightly. (Fig. 3)
Turn power on and then pull the chain on the light
kit fitter (F). The lights on the mounting plate (A)
should light up. Turn power back off and
disconnect male and female plugs. If mounting
plate (A) lights came on, please continue with
Step 4 on the following page; if mounting plate (A)
lights did not come on, repeat instructions in
“WIRING” section.
3.
3
Switch
Housing
Male Plug
Female Plug
F
A
To Next Page
Loading...
Need help?
General
