Hardi Commander Plus SPC Series User Manual

74
GB 14 08 04
Maintenance
Adjustment ofAdjustment of
Adjustment ofAdjustment of
Adjustment of
3-w 3-w
3-w 3-w
3-w
aa
aa
a
y-vy-v
y-vy-v
y-v
alvalv
alvalv
alv
ee
ee
e
The MANIFOLD valve can be
adjusted if it is too tight to oper-
ate - or if it is too loose (= liquid
leakage).
Correct setting is when the valve
can be operated smoothly by one
hand
Use a suitable tool and adjust the
toothed ring inside the valve as
shown on the drawing.
ChangChang
ChangChang
Chang
e ofe of
e ofe of
e of
b b
b b
b
ulbsulbs
ulbsulbs
ulbs
Overview of bulbs used.
T090-0006
ALLEH,pmalibmocraeR
noitcnuF)NID(epytbluBttaW/tloV
pmalraeRW5RW5/V21
pmalpotSW12PW12/V21
rotacidninoitceriDW12PW12/V21
)sdraobgninrawhtiw(AKEG,pmalibmocraeR
noitcnuF)NID(epytbluBttaW/tloV
pmalraeRW5RW5/V21
pmalpotSW12PW12/V21
rotacidninoitceriDW12PW12/V21
tnorf,pmalnoitisoP)AKEG(W5/V21
spmalkrowdnamooB
noitcnuF)NID(epytbluBttaW/tloV
pmalmooB3HW55/V21
pmalgnikroW89421W12/V21
ALLEH,pmaletalprebmuN
noitcnuF)NID(epytbluBttaW/tloV
pmaletalprebmuNW01RW01/V21
pmalibmocgnikramediS
.blubehtevomerotgnisuohrebburehtmorfylluferacsnelehttuoesirP
noitcnuF)NID(epytbluBttaW/tloV
ibmocgnikramediS
pmal
wolleyder,etihw
W5RW5/V21
039
To change a bulb
1. Switch off the light
2. Loosen the screws on the lamp and remove the cover
or lens.
3. Remove the bulb
4. Fit a new bulb, refit the cover and tighten the screws.
NOTE! If halogen bulbs are used, never touch the bulb
with the fingers. Natural moisture in the skin will cause
the bulb to burn out when the light is switched on.
Always use a clean cloth or tissue when handling halo-
gen bulbs.
Adjustment ofAdjustment of
Adjustment ofAdjustment of
Adjustment of
slanting indica slanting indica
slanting indica slanting indica
slanting indica
tor (iftor (if
tor (iftor (if
tor (if
f f
f f
f
itted)itted)
itted)itted)
itted)
If the position of the pointer on
the indicator does not correspond
to the actual boom position, the
pointer A can be adjusted.
1. Loosen the small bolt B
sufficiently to allow the wire C
to be adjusted.
2. Place the pointer A in correct
position and fasten bolt B
against the wire C again.
T112-0008x

Hardi Commander Plus SPC Series Specifications

General

Brand	Hardi
Model	Commander Plus SPC Series
Category	Farm Equipment
Language	English