3
Operator safety
Watch for the WARNING symbol
. Your safety is involved so be alert!
Note the following recommended precautions and safe operating prac-
tices.
Read and understand this instruction book before using the equipment.
It is equally important that other operators of this equipment read and
understand this book.
Turn electrical power o before connecting and disconnecting the display
and transducers, servicing or using a battery charger.
If an arc welder is used on the equipment or anything connected to the
equipment, disconnect power leads before welding.
Test with clean water prior to lling with chemicals.
Keep children away from the equipment.
Do not use a high pressure cleaner to clean the electronic components.
Press the keys with the underside of your nger. Avoid using your nger-
nail.
If any portion of this instruction book remains unclear after reading it, con-
tact your HARDI dealer or HARDI service personnel for further explanation
before using the equipment.
Description
The HARDI Monitor 1500 and HARDI Controller 2500 are for use in agricultural
and horticultural production. HM 1500 is a monitor whereas HC 2500 permits
automatic control of application rate.
Main components are:
• Display
• Flow transducer
• Speed transducer
The matrix display has two lines permitting two lots of information to be
shown at the same time. Display readout includes dosage applied, speed, liq-
uid rate per minute, total covered area, total volume sprayed and 9 trip tellers
for area covered and volume sprayed. It is illuminated internally so readout is
possible even for night-time work.
To Next Page
Loading...
Need help?
General
