59
4 - Sprayer Setup
General Info
Unloading the Sprayer
To unload the sprayer, you need a crane. When unloading the sprayer
with a crane, please observe the lifting points as shown in the picture,
and make sure that the straps or belts used for lifting can handle the
load.
€
DANGER! Lifting of machines require special training according
to national regulations.
μ
ATTENTION! Only lift the sprayer with empty tanks!
Before Putting the Sprayer Into Operation
Although the sprayer has been supplied with a strong and protective surface treatment on steel parts, bolts etc. in the
factory, it is recommended to apply a film of anti-corrosion oil (e.g. CASTROL RUSTILO or SHELL ENSIS FLUID) on all metal
parts in order to avoid chemicals and fertilizers discolouring the paint or surface-treated parts.
If this is done before the sprayer is put into operation for the first time, it will always be easy to clean the sprayer and keep
the paint or surface-treated parts clean for many years. This treatment should be carried out every time the protection film
is washed off.
To Next Page
Loading...
Need help?
General
