Harmar Mobility Pinnacle SL600 - Maintenance and Care Guidelines; Battery Maintenance and Replacement; Technical Maintenance and Optional Features; Cleaning Procedures for the Stairlift

SL600 PINNACLE STAIRLIFT: Owner’s Manual
22MAR24 | 76016 E
14
MAINTENANCE AND CARE
PINNACLE STAIRLIFT: SECTION 4
SECTION 4
MAINTENANCE AND CARE
The LED indicator light will turn red if there is a service issue. Turn the “On/Off” switch to the “Off” position
and then back to the “On” position. The lights should sequence red-amber-green. If the light does not return to
green, please contact your dealer.
BATTERY MAINTENANCE
• Ensure the stairlift is kept fully charged at all
times for optimal performance.
• Automatic charging occurs when the lift stops
within three (3’) feet at an upper or lower
landing.
• Keep the power supply plugged in continuously,
and the lift can be left on charge indefinitely.
• A fully charged battery displays a solid green
light, while a charging battery shows a solid
amber light on the chassis.
Note: The stairlift must be turned “ON” for battery
charging to occur; batteries do not charge when the lift is
turned “Off”.
BATTERY REPLACEMENT
• On average, replace batteries every 1-2 years
based on usage.
• Contact your local dealer for proper battery
replacement.
TECHNICAL MAINTENANCE
• The lift requires minimal technical maintenance
for consistent full capacity operation.
• The drive system does not use grease or
lubricants, and no adjustments should be
necessary.
• An annual inspection is recommended.
POWER SWIVEL (FOR UNITS
EQUIPPED WITH OPTION)
• During the annual inspection, inspect and
tighten the limit bolt if necessary.
POWER FOOTREST (FOR
UNITS EQUIPPED WITH OPTION)
• Regularly inspect the footrest for any signs of
looseness or failure to fully raise to the top
position. If you notice any issues, contact your
dealer for necessary adjustments.
CLEANING
• Keep the lift and rail clean to prevent dust
buildup and soiling.
• Use a damp, soapy cloth followed by a clean,
damp cloth for the seat, footrest, chassis and
upholstery.
• Avoid abrasive cleaners to prevent damage to
the finish.
• For heavy soiling, clean by scrubbing lightly with
a soft brush.
Non-compliant baeries may lead to product
malfuncon.
Annual inspecon is crical to idenfy baery
condion.
WARNING
!