SL600 PINNACLE STAIR LIFT: Install Manual
30SEP2020 | P/N: 76015 REV F
6
PREPARATION
PINNACLE STAIR LIFT: SECTION 3
SECTION 3
PREPARATION
Installations may vary to some degree, but below
are the basic tools to have on hand for a Pinnacle
stair lift installation.
If you have any questions, concerns or comments,
please contact our Technical Service Department at
800-833-0478 or tech@harmar.com.
REQUIRED TOOLS
• Cordless drill
•
• Phillips screwdriver (#3)
•
•
• Level
• Hack saw or chop saw
• SAE socket set
• SAE wrenches
• Tape measure
• Volt meter
INCLUDED PARTS
Before beginning installation, inspect and check
the box contents and report any damage or missing
items to Harmar.
• Chassis
• 2 wireless call/send hand controls
• Manual override tool (optional)
RAIL BOX CONTENT:
• Bottom rail pre-installed with:
− Bottom end plate
− Charge strip wire harness
• Bottom limit cam
• Joint pins (two-piece rail only)
• Plastic gear rack
• Top rail pre-installed with charge strip wire
harness.
• Rail accessories (plastic bag) with:
− Top end plate
− Compression bolts (2 sizes)
−
− Torx T30 driver bit
− Extra plastic racks (2 or 3)
− Top limit cam
RAIL BRACKET BOX:
• Rail brackets (2, 3, 4, or 6 per set)
•
CHAIR AND FOOTREST BOX:
• Chair with retractable seatbelt
• Footrest complete with adjustable seat height
frame
• Plastic vertical cover
• 5 nylon plugs
• Seat swivel post with fasteners
To Next Page
Loading...
