Harmonic ProStream X - ProStream X Installation Procedures; Getting Started with ProStream X Installation; Rack Mounting and Servicing Warnings

Chapter 2
Installing ProStream X
The installation process for the device.
• Before you start
• Chassis warnings for rack mounting and servicing
• Attaching the rack rails
• Rack mounting the chassis
• Installing the bezel
• Cabling the device
• First time device setup
• Setting the device's management IP address
• Configuring the Integrated BMC Web Console
• Licensing information
Before you start
What you need to know before you install ProStream X.
TIP: When you receive the ProStream X device, check the contents of the box against
the packing list to be sure that all parts are included. If any items are missing, contact your
local Harmonic representative immediately.
Chassis warnings for rack mounting and servicing
Follow these guidelines whenever rack mounting or servicing a ProStream device.
CAUTION:
To prevent bodily injury when mounting or servicing this unit in a rack, you must take
special precautions to ensure that the system remains stable. The following guidelines are
provided to ensure your safety.
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• If the rack will hold a number of units, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or
servicing the unit in the rack.
14