Harris RF-5800H - CHAPTER 6 TROUBLESHOOTING

6-1
RF-5800H 150-WATT COMMUNICATION SYSTEM
TROUBLESHOOTING
CHAPTER 6
TROUBLESHOOTING
6.1 INTRODUCTION
6.1.1 General
This chapter provides troubleshooting data necessary for fault isolation to the Line Replaceable Unit (LRU) level.
6.1.2 Scope of this Chapter
See Figure 6-1. The procedures presented in this chapter assume that a Level I fault has led the maintainer to suspect
a fault with the RF-5800H 150-Watt Communication System. The maintainer begins the troubleshooting process by
using the maintenance turn-on procedure to find a fault indication that identifies the faulty LRU. If there is a
non-Built-In Test (non-BIT) fault, the maintainer will use the non-BIT troubleshooting procedures. If there is a BIT
fault, the maintainer will use the BIT troubleshooting procedures. Troubleshooting Analysis Procedures (TAPs) are
provided to help the maintainer isolate faults using procedures other than simple unit swapping. When the problem
is found and corrected, the radio system is returned to operational readiness.