Harris RF-5800H - APPENDIX A; A.1 TECHNICAL SPECIFICATIONS

A-1
RF-5800H 150-WATT COMMUNICATION SYSTEM
APPENDIX A
APPENDIX A
A.1 TECHNICAL SPECIFICATIONS
NOTE
Because Harris engineers continuously strive to improve all
aspects of Harris equipment, specifications are subject to
change without notice.
Table A-1 provides RF-5833H-PA power amplifier specifications.
Table A-1. RF-5833H-PA 150-Watt Power Amplifier Specifications
Function Specification
Frequency Range 1.6 MHz to 59.99999 MHz
RF Input/Output Impedance 50-ohm nominal, unbalanced
RF Drive (Input)
Requirements
+20 dBm (100 mW)
RF Power Output 150 watts PEP/Average into a 50-ohm load (1.6 MHz to 29.99999 MHz)
60 watts PEP/Average into a 50-ohm load (30.0 MHz to 59.99999 MHz)
Intermodulation Distortion 25 dB below 150-watt PEP (1.6 MHz to 29.99999 MHz)
25 dB below 60-watt PEP (30.0 MHz to 59.99999 MHz)
Harmonic Output 45 dB below 150-watt PEP (1.6 MHz to 29.99999 MHz)
45 dB below 60-watt PEP (30.0 MHz to 59.99999 MHz)
DC Power Input +28.0 VDC (per MIL-STD-1275) at 20 A maximum
Voltage +23 VDC to +30 VDC
Temperature Range -40° C to +70° C
Environmental MIL-STD-810E
Heat Dissipation to Air 395 W
Cooling Air Flow Required 106 Cubic Feet per Minute (CFM)
Relative Humidity 0 to 95%
Leakage MIL-STD-810E (1 meter depth)
Size 10.38 W x 15.50 D x 6.5 H in. (Power Amplifier and Receiver-Transmitter)
(26.34 W x 39.37 D x 21.78 H cm)
Weight 32.7 lbs. (14.84 kg) (Power Amplifier) plus
8.5 lbs. (3.86 kg) (Receiver-Transmitter) equals 41.2 lbs. (18.7 kg)