14
OPERATING THE MACHINE
MITRING WITH THE MITRE FENCE
SAFETY
When mitring NEVER use the ripping fence
as a stop.
1 Put the saw-blade in its highest position.
2 Put the material on the machine (fig. 7).
3 Push the wood against the fence.
Notice: Support the wood properly.
4 See to it that the wood and the fence do
not touch the saw-blade.
5 Switch on the motor.
6 Move the fence and the wood forward at
a constant speed and cut the material.
7 Switch off the motor.
8 Remove the material after the saw-blade
has stopped.
Notice: If the saw-blade stops because of
clamping of the wood, switch off the motor.
Hold the piece of wood tightly!
Notice: Never stand in the line of the saw-
blade. In case of a return shock you might
get hit.
Figure 7
To Next Page