19
MAINTENANCE
CLEANING, LUBRICATING AND
GREASING
40 PRODUCTIVE HOURS
Perform following maintenance every 40
productive hours.
1 Clean the tubes of the height adjustment
and also the spindle. Lubricate slightly.
2 Clean the rail fence and the knob of the
fine adjustment.
3 Clean the spindle and the stop of the
angle adjustment. Lubricate slightly.
4 Brush the air inlet and parts of the motor
and check if it is not obstructed.
5 Remove plates at front and back side of
table. Clean segments and blow clean.
Lubricate slightly. Mount plates again.
160 PRODUCTIVE HOURS
Perform following maintenance every 160
productive hours.
5 Wear and tear of cables.
6 Broken or torn parts of the electric circuit.
7 Brake time of saw-blade (has to be less
than 10 seconds).
8 Operation and condition of safety guard.
9 Free outlet of dust collector to dust
extractor.
1000 PRODUCTIVE HOURS
Perform following maintenance every 1000
productive hours.
10 The bolt connections of the height and
angle adjustment.
11 Check saw spindle for backlash.
12 The bolt and nut connections of the
motor.
To Next Page