9
CONNECTING THE ELECTRIC SUPPLY
A skilled craftsman may only do connecting the
machine.
MACHINE CONNECTION
380 V- 3 PHASE
(see wiring diagram)
1 Disconnect mains supply.
2 Open switch at the backside of the
machine (fig. 2).
3 Connect the 5-core cable at the same
points.
Black (1] = Phase
Black [2] = Phase
Brown [3] = Phase
Bleu [4] = Zero
Yellow/green [5] = Earth
the 3 phases L1. L2, L3
- MP for the zero
- PE for the earth
4 Close the switch.
Notice: Use cartridge fuses of min. 25 Ampere.
Notice: Check the rotation of the saw (see
chapter DIRECTION OF SPINDLE
ROTATION).
Figure 2
To Next Page
Loading...