18
MALFUNCTIONS
Safety
Disconnect the machine of the mains supply
before adjusting the machine or removing
malfunctions.
See to it that all damaged parts are replaced
before operating the machine.
MALFUNCTION:
WOOD CLAMPS ON RIVING KNIFE
0 Check thickness, measure and position
of riving knife (see chapter : ADJUSTING
RIVING KNIFE).
MALFUNCTION:
BRAKE DOES NOT WORK
0 Switch off the machine and contact you
dealer or the producer how to adjust the
brake.
MALFUNCTION:
SAW-BLADE DOES NOT ROTATE
1 Disconnect mains supply.
2 Check if the saw-blade can run freely.
3 Check if the saw-blade is fitted properly
(see chapter: CHANGING SAW-BLADE).
4 Check if the saw-blade is mounted
properly between the front and back
flange.
Have you checked all this, but the problems is
not solved contact you dealer.
To Next Page