3
APPLIANCE
The sawbench type 130 is only to be used for
cutting wood and wood-like panels (e.g.
chipboard, block board, MDF etc.)
Maximum panel sizes:
Height: 110 mm
Between saw-blade and
rip fence: 1250 mm
Length (not supported): 1000 mm
Cutting of other materials with the standard
saw-blade is prohibited. Cutting other materials
with a special saw-blade only with permission of
manufacturer.
All other appliances except for the above are
improper use of the machine and therefore
prohibited. The producer cannot be held
responsible for damage as a result of improper
use. Damage will be recovered from the user
The machine may not be operated, used or
maintained by persons not acquainted with the
risks of the machine.
Permission for operating, using and maintaining
the machine have to be clearly described by a
person or persons responsible within the
organisation.
Maintenance has to be performed by the
manufacturer or customer service.
One has to be acquainted and comply with the
country's applicable safety regulations.
Only original Harwi parts are to be used.
We cannot give warranty or be held responsible
for damage caused by using non-original Harwi
parts.
The manufacturer cannot be held responsible
for damage caused by changes made to the
machine by the user.
REMAINING RISKS
If the machine is completely used according
to all safety regulations there still will
remain some risks:
Touching of the saw-blade with the
sawing area.
Touching of the saw-blade when the lid is
opened
Breaking of the saw-blade or parts of the
saw-blade hurtling out of the guard.
Touching of parts under voltage while
junction box or switch is opened.
Damage to the hearing by constant use
of the machine without ear protection.
Throw out of harmful dusts or vapours by
using a dust extractor with bad
performance or no dust extractor at all.
To Next Page
Loading...