HARWI 625-U - OPERATING THE MACHINE: TILTING MOTOR

10
OPERATING THE MACHINE
CUTTING AT AN ANGLE UNDER 45º (625-U)
B.M.O. TILTING THE MOTOR
1 Move the carriage to the front (Fig. 3).
2 Fasten the carriage with the blocking
knob, on top of the unit.
3 Turn the saw unit completely upwards
with the handle on top of the carriage.
4 Keep your right hand at the bottom side
of the motor en loosen the handle with
your left hand. Push the motor with your
right hand, against the 45º stop.
5 Fasten the handle with you left hand.
6 Turn the saw unit downwards with the
handle.
7 The top side of the yellow measure pointer
has to be approx. 2 mm under 0 mm.
8 Loosen the blocking knob on top of the
carriage.
9 Let the carriage run backwards behind the
stop.
10 The machine is ready for cutting.
11 Motor from 45º to 0º; put your right hand
at the bottom side of the motor, loosen the
handle with your left hand. Support the
motor with you right hand till 0º.
Figure 3