Need help?Do you have a question about the HARWI 625-U and is the answer not in the manual?
Step-by-step instructions for securing the machine to the floor.
Instructions to verify the correct clockwise rotation of the spindle.
Guide for performing square mitre cuts relative to the fence.
Steps for adjusting the arm to cut at a 45-degree angle.
Guide to swinging the arm for cuts between 0 and 45 degrees.
Instructions for tilting the motor for cuts between 0 and 45 degrees.
Instructions for performing cuts using compound angles.
Procedure to tighten the counter balancer spring using a plastic key.
To Next Page
General