14
MAINTENANCE
COUNTER BALANCER
Takes the saw-blade automatically back behind
the stop in the 0-position (Fig. 7).
TIGHTEN THE SPRING
1 Put the carriage in the 0-position.
2 Put the delivered plastic key in the hole at
the front side of the counter balancers.
3 Turn the key clockwise (+).
LOOSEN THE SPRING
1 Put the carriage in the 0-position.
2 Push the control spring between the
counter balancer and the support
downwards.
3 The counter balancer can be adjusted at
the proper tension.
Figure 7
To Next Page
Loading...