3
APPLIANCE
The radial arm saw type 625-H, 625-U en 625-
2-K are to be used for cutting wood and wood-
like panels, and with the proper saw-blade
plastics and non-ferrous materials.
Maximum material sizes are:
Height: 135 mm
Cutting length standard 625 mm
Cutting of other materials with the standard saw-
blade is prohibited. Cutting of other materials
with the proper saw-blade only with permission
of manufacturer.
All other appliances except for the above are
improper use of the machine and therefore
prohibited. The manufacturer cannot be held
responsible for damage as a result of improper
use. Damage will be recovered from the user.
The machine may not be used, operated or
maintained by persons not acquainted with the
risks of the machine.
Permission for operating, using and maintaining
the machine have to be clearly described by a
person or persons responsible with the
organisation.
Maintenance has to be performed by the
manufacturer or customer service.
One has to be acquainted and comply with the
country’s applicable safety regulations.
Only original Harwi parts are to be used. We
cannot give warranty or be held responsible for
damage caused by using non-original Harwi
parts.
The manufacturer cannot be held responsible
for damage caused by using non-original Harwi
parts.
REMAINING RISKS
If the machine is completely used according to
all safety regulations there still will remain some
risks:
Touching of the saw-blade within the sawing
area.
Touching of the saw-blade when the lid is
opened.
Breaking of the saw-blade or parts of the
saw-blade hurtling out of the guard.
Touching of parts under voltage while
junction box is opened.
Damage to the hearing caused by constant
use of the machine without ear protection.
Throw out of harmful dusts or vapours by using
a dust extractor with bad performance or no
dust extractor at all
To Next Page
Loading...
