Haskris WW3 - Controller Display; Main Display; Status Modes

Page 20 of 26
Email: service@haskris.com
Phone: 001 847 956 6420
IX. Controller Display
Main Display
Status
Indicates the state of the heat exchanger
Supply Set Value
The desired temperature for the water
Present Value - Supply
Measured supply temperature
Flow Rate
Measured value of the flow rate on each cooling circuit
Description of main display data
Status Modes
ON
The ON/OFF switch is in the ON position and the pump is running
City water backup is not active
Note that on some programs the status text is blank when the unit is ON
OFF /
City Water
The physical ON/OFF switch is in the OFF position
City water backup is active
OFF→Alarm /
City Water
An alarm or fault occurred and stopped the heat exchanger
City water backup is active
OFF by BMS
The site’s BMS is connected to the heat exchanger and sending it a signal to be OFF
City water backup is active
Description of status modes
Status
Supply Set Value
Units of Measure
Flow Rate – Coil
Flow Rate – Comp.
Present Value – Supply
Main display
Flow Rate – Amp
Flow Rate – RF Cabinet
(if applicable)