25
• Long-term storage of batteries with very low charge is not recommended.
• The battery has a limited life and its performance is gradually reduced over
time.
• It is advisable to follow the recommendations and precautions in this manual for
product performance and safety reasons.
Rechargeable battery grip – precautions
e following precautions should be adhered to:
Battery grip rechargeable 7.2 V:
• Connect the battery grip to the camera correctly.
• Keep the protective cover in place when not in use. (Short-circuiting across keys
in a pocket, for example, could cause a fire risk).
• Do not use the battery grip for anything other than the H1/H2 camera.
• Do not immerse the battery grip in liquids.
• Do not incinerate the battery grip. Please recycle or discard in an environmentally
approved manner.
• Do not use any other charger than the Hasselblad battery charger BC-H Li-ion 7.2
VDC (3053568).
Battery charger BC-H Li-ion 7.2 VDC:
• Read the instructions before using the charger.
• Use indoors only (protect against moisture).
• Do not use charger for anything else than charging of Battery grip rechargeable
7.2 V (3043348).
• Do not short-circuit the jack plug.
• Do not alter the charger in any way other than changing the plug
attachment.
Viewfinder screen 9, 10
e H2 is fitted with a Spherical Acute-Matte D viewfinder screen
for extreme brightness, clarity and even illumination. An optional
accessory screen with a grid pattern is also available.
To change a viewfinder screen, remove the viewfinder to access
the viewfinder screen. To remove the screen, place the tip of a
ballpoint pen or similar in the viewfinder screen removal lug
and pull upwards. To replace the screen, position the right side of
the screen in place so that it sits correctly in the recess. Place the
tip of a ballpoint pen or similar in the viewfinder screen replace-
ment indentation and press downwards until the screen snaps
into position. Try to avoid touching either surface of the screen
with bare fingers.
Do not attempt to clean the screen by immersing it in water, or
use any kind of cleaning fluid. If the screen becomes damp, do not
use hot air to dry it. Use a soft cloth on the upper surface only. Seek
advice from an Authorized Hasselblad Service Center if the screen
becomes particularly soiled. Remember that particles or greasy
marks on the screen might impair the viewfinder image but have
no effect whatsoever on the recorded image.
10
9
To Next Page
Loading...
Need help?
General
