you want and then press the Load (AF) button. All the saved set-
tings will then be automatically implemented.
If you decided to change the settings but nevertheless keep the
Profile name on the list, the new set of parameters will be retained
under that name. That is to say, the settings will not be the same
as listed here, despite the name. It might be safer practice to always
change the profile name to avoid later confusion.
Using profiles
1) From the main screen, click PROFILES (ON.OFF button) on
the grip and the profile screen will appear.
2) Use either the front or rear control wheel to scroll through the
list and highlight the desired profile.
3) Press Load (AF button). The camera is now set according to
all the parameters stored according to the name.
Changing a profile name
You can change a profile name (except ‘Standard’) at any time.
Proceed as follows:
1) From the main screen, click PROFILES (ON.OFF button) on
the grip and the profile screen will appear.
2) Use either the front or rear control wheel to scroll through the
list and highlight the desired profile.
3) Press Load (AF button).
4) Click PROFILES (ON.OFF button) again.
5) Press Save (DRIVE button)
6) The Profile name screen is then displayed where you can
rename the profile to what suits you (see section Imprint / Text
4.2.2 further on in this manual for procedure details).
To Next Page
Loading...
Need help?
General
