Customizable button function list
• The USER, AE-L, STOP DOWN and M.UP buttons can all be reassigned to different functions.
• The USER button has no function until specifically assigned one (default is ‘None’). The AE-L, STOP DOWN and M.UP
buttons, however, by default are assigned the function appropriate to the name, until assigned otherwise.
None
e user button has no function.
Standby
Sets the camera in standby mode to save battery consump-
tion.
Stop down
Stops the lens down.
Flash Measure
Initiates ash measure function.
Interval timer
Initiates interval timer function.
Multi exposure
Initiates multi exposure function.
Self timer
Initiates self timer function.
Bracketing
Initiates bracketing function.
AF Drive
Activates the AF system in any focusing mode. When the
button is pressed the AF system sets the correct focusing point
automatically. is is a rapid, accurate and handy way of
using the AF system when the camera is set to Manual focus
mode. In this manner you take advantage of the accuracy
and certainty of the autofocus system while retaining the
control inherent in manual focusing mode.
A quick way to program the customizable buttons (and
to access the Custom Option level in general) is to use
the short-cut as follows:
1) Press the MENU button.
2) Then press the
USER button.
This directly accesses the “Custom options” level in the menu
where you can access the desired option for a setting change.
Mirror up
Controls the mirror up or down function (same function as
the M-UP button).
B mode
Sets the camera to B exposure mode.
T mode
Sets the camera to T exposure mode.
Cycle LM mode
Changes the light-metering method in a loop manner: Centre
Weighted/Average/Spot.
................................................................................................
The following do not function when a film
magazine is attached:
Histogram
Recalls the last shown histogram on the grip LCD.
Grey balance exp.
Initiates a grey balance exposure using the marker frame
to select the desired tone.
Delete last image
Activate the delete function for the last image in a digital
back.
(to be implemented at a later stage)
Dig. foc check
Displays last exposure taken at 100% scale on digital backs
with LCD.
The buttons can be assigned or reassigned to the following functions:
106
To Next Page
Loading...
