Hasselblad H3D 31MPix - View F Inder Screen; Accessor y Connec Tion; PC-Connec Tor; Base Plate

17
16
19
18
Viewnder screen 14, 15, 16
e H3D is tted with a Spherical Acute-Matte D viewnder screen
for extreme brightness, clarity and even illumination. An optional
accessory screen with a grid pattern is also available.
To change a viewnder screen, remove the viewnder to access
the viewnder screen. To remove the screen, place the tip of a
ballpoint pen or similar in the viewnder screen removal lug and
pull upwards. To replace the screen, position the right side of the
screen in place so that it sits correctly in the recess. Place the tip
of a ballpoint pen or similar in the viewnder screen replacement
indentation and press downwards until the screen snaps into
position. Try to avoid touching either surface of the screen with
bare ngers.
 Do not attempt to clean the screen by immersing it in water,
or use any kind of cleaning uid. If the screen becomes damp,
do not use hot air to dry it. Use a soft cloth on the upper sur-
face only. Seek advice from an Authorized Hasselblad Service
Center if the screen becomes particularly soiled. Remember
that particles or greasy marks on the screen might impair the
viewnder image but have no eect whatsoever on the recorded
image.
Accessory connection 16, 17
On the le hand side of the camera body are two accessory retaining
screw threads (M5), as well as a databus connector, protected be-
neath a cover. e screw threads are a future-safe design feature for
new products while the connector is for service purposes only.
e cover can be removed by inserting a pointed object, such as
a pen, in the small hole and then sliding it to the le, as in the il-
lustration. e retaining clip can then also be removed to access
the connector.
PC-connector
A PC connector for non TTL-ash synchronisation is located on
the le side of the body. It is protected by a captive rubber plug.
Protective base plate 18, 19
To attach the protective base plate, slip it over the camera foot
until it stops. To remove it, li the securing catch while pushing
the plate back as in the illustration.
15
14
Viewnder screen showing compo-
sition frame marking (22/39MPix).
21
Viewnder screen showing compo-
sition frame marking (31MPix).