Hasselblad H3D 31MPix - Changing a Prof Ile Name

ON.OFF
(PROFILES/ESC)
1
&
2
2
$2)6%
3AVE
AF
Loa d
3
ON.OFF
(PROFILES/ESC)
1
&
2
2
$2)6%
3AVE
AF
Loa d
3
ON.OFF
(PROFILES/ESC)
4
5
$2)6%
3AVE
4) Press Save (DRIVE button).
The Prole name screen is then displayed where you can
rename the prole to what suits you (see section Imprint /
Text 4.2.2 further on in this manual for procedure details).
5) Press Save (DRIVE button) to keep the combination of settings
with the new name.
To use a prole from the main screen, press the PROFILES button
to reach the proles screen again. Scroll down the list to the prole
you want and then press the Load (AF) button. All the saved set-
tings will then be automatically implemented.
If you decided to change the settings but nevertheless keep
the Prole name on the list, the new set of parameters will be
retained under that name. That is to say, the settings will not
be the same as listed here, despite the name. It might be safer
practice to always change the prole name to avoid later
confusion.
Using proles
1) From the main screen, click PROFILES (ON.OFF button) on
the grip and the prole screen will appear.
2) Use either the front or rear control wheel to scroll through the
list and highlight the desired prole.
3) Press
Load (AF button). The camera is now set according to
all the parameters stored according to the name.
Changing a prole name
You can change a prole name (except ‘Standard’) at any time.
Proceed as follows:
1) From the main screen, click
PROFILES (ON.OFF button) on
the grip and the prole screen will appear.
2) Use either the front or rear control wheel to scroll through the
list and highlight the desired prole.
3) Press
Load (AF button).
4) Click
PROFILES (ON.OFF button) again.
5) Press
Save (DRIVE button)
6) The Prole name screen is then displayed where you can
rename the prole to what suits you (see section Imprint /
Text 4.2.2 further on in this manual for procedure details).
87