AF
Interval
3 Interval
By using the interval setting, you can allow the camera to take a series of
exposures automatically over a set period. This is often required for time
and motion studies, security surveillance, nature study, etc. The exposure
and focus settings (Manual or Auto) will be according to the camera set-
tings at the time of exposure.
Interval setting
1) Press the MENU button on the grip.
2) Turn the front control wheel until Interval appears.
3) Press the DRIVE (Enter) button on the grip.
4) Turn the front control wheel to access the options, that are:
Number of exposures
(the number of exposures required)
Interval duration
(the time interval between the exposures)
(e chosen symbol is indicated by a drop shadow)
5) In Number of exposures, turn the rear wheel to choose the
number of exposures required: 2 – no limit
6) In Interval duration, turn the rear wheel to choose:
1 second – 1 hour
7) Press SAVE (DRIVE button) to save the setting.
8) Press
ENTER (DRIVE button) again from the Interval screen
to activate the function. Press On (AF button). Note that this
now reads O and the line of text at the bottom of the screen
reads ‘Interval on’.
Half-press the shutter release button to standby mode for this
function (press the shutter release button again (full press)
for activation) or full-press the shutter release for immediate
activation.
In Custom Options #27 you can select an initial delay of None,
2, 10, 60 seconds or the interval time.
Check the lower text-row on the screen for ON or OFF status.
An Interval setting can be stopped mid-sequence by pressing
the ESC button.
Number of exposures highlighted. 2
frames variation chosen as option.
Interval duration highlighted. 5 sec-
onds variation chosen as option.
Screen after Interval setting activated
indicating 3 shots remaining at 30
second intervals.
94
ON
To Next Page
Loading...
