Hasselblad H3D 31MPix - Page 93

6
5
4
3
21
$2)6%
3AVE
9
8
7
A B C D
&
-%.5
$2)6%
%NTER
&
2
2
2
$2)6%
3AVE
$2)6%
%NTER
ON.OFF
(PROFILES/ESC)
Bracketing setting
The Bracketing function is set in the following manner:
1) Press the MENU button.
2) Turn the front control wheel until Bracketing appears
3) Press Enter (DRIVE) button on the grip
4) Turn the front control wheel to access the options, that are:
Number of Exposures (the number of exposures required
in the sequence)
Sequence (the sequential order of the over- or
under- exposures)
Step (the amount of EV variation from the standard
exposure setting)
(A drop shadow will be displayed beneath the selected symbol, for
example )
5) In turn the rear wheel to choose the number of frames
required: 2, 3, 5, 7 or 9.
6) In turn the rear wheel to choose one of four sequences:
A: Standard, Over, Under
B: Standard, Under, Over
C: Over, Standard, Under
D: Under, Standard, Over
7) In turn the rear wheel to choose the amount of EV variation
required: 1, 1/2, 1/3 EV.
8) Press SAVE (DRIVE button) to save the setting.
9) Press ENTER (DRIVE button) again from the Bracketing screen
to activate the function. Press On (AF button). Note that this now
reads O and the line of text at the bottom of the screen reads
‘Bracketing on’.
Half-press the shutter release button to standby mode for this
function (press the shutter release button again (full press) for
activation) or full-press the shutter release for immediate activa-
tion.
To escape from this mode press MENU, then Enter (DRIVE but-
ton on the Bracketing screen, then O (AF button).
Check the lower text-row on the screen for ON or OFF status
The default setting is a shutter speed change in a bracketing
sequence. However, if the camera is set in Manual mode, you
can choose an aperture change instead (Custom Options
- Bracket param. in Manual - 25).
 See note at the beginning of this section regarding the dier-
ence between Single and Continuous drive settings. In both
cases, the bracketing function is automatically reset for a new
sequence.
A bracketing sequence can be stopped mid-sequence by press-
ing the ESC (ON.OFF) button.
As an example, a 5 frame sequence with an EV 1 variation set-
ting at ‘Standard, Over, Under’ would produce: Standard (O EV
variation), +1EV, -1EV, +2EV, -2EV.
Number of exposures highlighted.
3 frames chosen as option.
Sequence highlighted. ‘Standard,
over, under’ chosen as option.
Step highlighted.
1/3 EV variation chosen as option.
Screen after Bracketing setting acti-
vated indicating 3 frames remaining
in a Standard, Over, Under, sequence
with no adjustment to the next frame.
Viewnder display indicating no
adjustment to next frame and three
frames left in the sequence.
EXAMPLE EXAMPLE
93