The HM 16-32 Film Magazine is an optional accessory.
3
1
2
5
2
4
Film loading
e lm magazine can be loaded either on or o the camera.
Regularly check the interior of the magazine and remove dust,
particles or any scraps of paper from previous rolls of lm. Load
and unload lm magazines away from direct light sources.
1) Fold out the lm holder key and turn it counter-clockwise 90°.
Withdraw the lm holder completely.
2) Place an empty take-up spool in the upper spool holder by
placing one end over the xed stud in the holder and the
other end underneath the sprung spool retaining arm. Rotate
the spool a little if necessary until it clicks into position.
3) Completely remove the retaining paper band from a new roll
of lm and place it in the lower spool holder. See diagram for
correct orientation. Ensure you do not place the lm spool the
wrong way around!
4) Pull 8–10 cm (3–4 in.) of paper backing from the lm roll and
insert the tongue of the backing paper into the slot in the
take-up spool. Turn the spool one complete turn to ensure the
tongue is rmly held in place by the overlying paper backing.
5) Re-insert the lm holder into the main body of the lm maga
-
zine ensuring the correct orientation. Press rmly inwards
towards the magazine and pay particular attention to see
that both sides are level with the magazine body before turn-
ing the lm holder key clockwise 90˚ to lock the lm holder in
place and fold the key back into its stored position. You might
nd that increased pressure on the left hand side of the lm
holder will more easily ensure a positive and correct position-
ing in the magazine.
If the camera is active or in standby mode the lm will be
wound automatically by the camera to position the rst
frame (this function can be changed in ‘Custom options’ so
that the lm is advanced only when the shutter release but-
ton is pressed the rst time).
Beeper
e beeper sounds immediately aer the last-but-one frame
has been exposed. is function can be turned o in Custom
Options.
1
1
2
121
To Next Page
Loading...
