3.16 BATTERY AND BATTERY GRIP
Rechargeable battery grip
The environmentally approved Battery grip Li-ion (3043357)
is the standard power source for the H6D camera. The H6D
requires a power supply for all actions as there is no mechanical
reserve facility. It is therefore advisable to keep a reserve
rechargeable battery grip at hand. As is the case with most
batteries, problems might be encountered when used in very
low temperatures. In this situation it is advisable to keep the
reserve battery in an inside pocket, for example, to maintain it
near body temperature.
Remove a battery
1 Remove the battery from the camera by pressing the battery
holder button (A) and simultaneously swinging the battery
holder retaining lever (B) down until it stops.
2 Pull the battery downwards (C).
Attach a battery
1 To t, hold the battery at against the camera body and align
the two upper lugs with the slot.
2 Slide the battery back into position.
3 Rotate the battery holder retaining lever (B) back until it
clicks into place.
Store a battery
If you intend to store the battery separate from the camera,
ensure the safety cover is mounted over the electric connections
on the battery to prevent short circuits. It snaps into place and
is removed by pulling outwards and upwards on the locking clip.
Connect battery to charger
1 Connect the charger plug to the plug connector on the inside
of the battery (D).
2 Connect the charger to the wall socket.
See next page for more in depth information.
A
B
C
D
H6D www.hasselblad.com
USER GUIDE
Overview
36
To Next Page
Loading...
